Bondtech HeatLink 12v 50W Heater

Bondtech HeatLink 12 V 50 W Heater

Have it your way!

This 12 V 50 W heater cartridge and cable uses a Molex Micro-Fit 3.0 female connector, allowing it to be extended with one of the HeatLink interface cables and connected to your printer without hassle.

The HeatLink range is an alternative group of thermistors and heater cables enabled with Molex Micro-Fit connectors, complemented by several short interface cables for connecting to dozens of 3D printer models for ease of use.

HeatLink is the answer to the growing demand for powerful heaters and high-temperature thermistors that are ready to use and easy to install.

Plug & Play thermistors and heaters from Bondtech. Ready to use on (at least) 25 different Creality and Prusa models.

Pair a Bondtech thermistor or heater with a HeatLink interface cable to plug into any printer without soldering or crimping.

Each interface cable is 50 mm long and fits entirely inside the control box.

Bondtech HeatLink Interface Cables Compatibility Table

HeatLink JST XH-2 W/ LOCK		HeatLink JST XHP-2	HeatLink JST VHR-2N	HeatLink JST SMP-02V-BC	HeatLink Molex MX-50-57-9002	HeatLink Ferrule
		Ender-6	CR-10S Pro CR-10S Pro V2 CR-10 Max CR-10 V2 CR-10 V3	Ender-5 Ender-5 Pro Ender-5 Plus		i3 MK3 / S / + i3 MK2.5 / S i3 MK2 / S CR-10 CR-10 mini CR-10 S CR-10 S4 CR-10 S5 CR-20 Pro CR-5 Pro CR-X Ender-3 Ender-3 Pro Ender-3 V2

The table above refers to connecting Bondtech HeatLink Thermistors only.