OpenR/C Formula 1 car

Designed by  DanielNoree

Add your car to the OpenRC buildmap: https://zeemaps.com/map?group=1888242

This is the OpenR/C Formula 1 car.  It´s the third generation OpenR/C car and this time around focus is on simplicity! You can print everything in PLA except the tires which are done in NinjaFlex! Of course you can print it in any material you like but for those that want to print a car but only have PLA at hand, this is the project for you!

A note on the servo saver. It´s designed to be used with PLA, the upper and lower BOM applies force similar to a spring in a convetional servo saver. Of course the pressure depends on the type of material used, infill etc. Fine tuning can be done adding washer under or over the servo saver.

The “Main Turning Vane´s” needs to have it´s lower part trimmed using a “exacto knife”. Then slide it the chassie plate and push it over the “Lid” and it should snap into place-

Any questions can be made in the Facebook group here: https://www.facebook.com/groups/1111886228841596/